Disconnect any serial monitor (Mu, Thonny, PuTTY, etc.) from the device.
Click "Connect" below and select the LumaFader from the port list.
Once linked, use physical controls (buttons/sliders) to navigate settings.
NOTICE:
If the device was plugged in while holding all 4 buttons (USB drive mode), settings will be read-only. Reconnect normally to enable writing.
Disconnected
[ awaiting serial handshake ]
Settings Cascade
Channel and type inherit downward — set Global and override only where you want a difference.
Slider Ch most specific
→Bank→Page→Global
Pages & Banks
4 pages, each with 4 banks. A bank stores its own CC numbers for the sliders and can override the page/global channel and type; no bank selected = Global values. On the device: hold button 1 + tap 4 for next page (4 + tap 1 for previous), press a button to select its bank, double-press to lock it.
Sliders (A–D)
Set each slider's CC number, and optionally a per-slider Ch override (blank = inherit). Moving a physical slider highlights its field here.
Channels
For several channels at once, separate with a pipe: 1|2|5.
Message Type
CC — Control Change. AT — Channel Aftertouch: sends the value as channel pressure; the CC number is ignored.
MIDI Learn
Click Learn under a slider, then send a CC from your gear to assign it. Tick Learn Ch to also grab the channel. Times out after 30s.
Record Mode
Hold all 4 buttons for 3s to enter or exit. The buttons become 4 loop pads: double-click empty to record, single-click to stop/play, double-click then click again to delete (red blink confirms). Pad LED: red recording, green playing, white stopped.
Each bank has its own 4 pads — navigate banks for a fresh set, and loops in other banks keep playing so you can layer. Loops are RAM-only and clear on power-cycle. The ? by "Global" explains the record settings.
Saving
Save Settings, then unplug and re-plug the device for changes to take effect.